寬頻主動式半循環器與平衡器研製;Design and Analysis of Wideband Active Quasi-Circulator and Active Balun

NCU Institutional Repository > 資訊電機學院 > 電機工程研究所 > 博碩士論文 > Item 987654321/54508

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/54508

题名:	寬頻主動式半循環器與平衡器研製;Design and Analysis of Wideband Active Quasi-Circulator and Active Balun
作者:	涂聖強;Tu,Sheng-chiang
贡献者:	電機工程研究所
关键词:	寬頻放大器;主動式半循環器;共模拒斥比;主動式平衡器;CMRR;DA;active balun;quasi-circulator
日期:	2012-07-11
上传时间:	2012-09-11 18:52:10 (UTC+8)
出版者:	國立中央大學
摘要:	現今無線通訊技術快速的發展，切換器(switch)與雙工器(diplexer)電路主要用於前端收發系統中區隔收發訊號的功能，固然切換器作為分隔收發訊號的功能有不錯的隔離度且不會有直流功耗，但接收與發射的訊號不能同使開啟。而雙公器也擁有分隔收發訊號的能力，不同於切換器的地方乃是其利用雙頻帶的方式來實現，因此接收訊號的頻帶不同於與發射訊號的頻帶。而半循環器(quasi-circulator)則擁有兩者所沒有的優點，半循環器在區隔收發訊號時，可以同時並使用相同頻帶來完成訊號傳送，故此本論文將著眼探討如何設計並且分析半循環器電路。根據已發表的論文中，使用主動式半循環器的文獻相較於其它電路的量是較少的，因此在本論文的第一章將列舉出幾種不同架構的主動式半循環器電路，並針對各個架構的作一簡單的介紹，方便讀者能快速了解其電路的運作原理。第二章為分別利用穩懋半導體股份有限公司提供的0.5 µm E/D-mode PHEMT與HBT/HEMT 2 µm/0.5 µm製程，台積電提供的CMOS 0.18 µm 製程技術並且搭配相位補償技術製作出3.2 ~ 14 GHz、5 ~ 20.2 GHz與3.9 ~ 32.7 GHz的主動式半循環器，插入損耗分別為-6 ~ -3 dB、-6.3 ~ -2.5 dB與-8 ~-4.8 dB。第三章則是使用穩懋半導體公司所提供的0.5 µm E/D-mode PHEMT製程技術實現出DC ~ 15 GHz的主動式平衡器，在頻帶內振幅誤差小於0.15 dB，相位誤差小於1度，小訊號增益大於5 dB，而後進一步利用此設計的主動式平衡器搭配達靈頓放大器實現出DC ~ 12 GHz的寬頻主動式半循環器，小訊號增益大於5 dB，在此頻寬範圍內隔離度均大於18 dB。第四章利用台積電所提供CMOS 90 nm製程，延伸第三章的理論推導分析，搭配疊接分佈式達靈頓放大器設計出4.4 ~ 42 GHz的寬頻主動式半循環器，隔離度表現大於22 dB，小訊號增益大於-1 dB。第五章則是利用台積電所提供CMOS 90 nm製程，設計兩組矩陣分佈式放大器與三組堆疊二維方向正交耦合器成功實現40 ~ 83 GHz的主動寬頻半循環器，平均隔離度在頻寬範圍內大於12 dB，小訊號增益大於0 dB。As the wireless communications are rapidly developing, the switch or diplexer is widely used in a transceiver for time or frequency division. The switch has good isolation between transmitter and receiver with no DC power consumption, but it cannot be used for the full diplexing system. The diplexer can be used to separate the receiving and transmitting signals, but the receiving frequency is different from the transmitting frequency. A quasi circulator can be adopted to connect the transmitter and the receiver with an antenna as a duplexer when the transmitting frequency is the same as the the receiving frequency. So this thesis will focus on the design and analysis of the quasi circulator.According to the previously published literatures, a few active quasi circulators have been reported. Several different architectures of the active quasi circulators are introduced in Chapter 1, and the principle of operation is also presented. In Chapter 2, a phase compensation technique is adopted to improve the isolation of the active quasi circulator. Three active quasi circulators are successfully developed using 0.5 µm GaAs E/D-mode PHEMT, 2µm /0.5 µm GaAs HBT-HEMT, and 0.18 µm CMOS processes, respectively. Between 3.2 and 14 GHz, the insertion gain of the E/D-mode PHEMT quasi circulator is from -6 to -3 dB. Between 5 and 20.2 GHz, the insertion gain of the HBT-HEMT quasi circulator is from -6.3 to -2.5 dB. Between 3.9 and 32.7 GHz, the insertion gain of the CMOS quasi circulator is from -8 to -4.8 dB.In Chapter 3, an innovative circuit topology for active balun/quasi circulator is investigated to further enhance the performance. A DC-to-15 GHz active balun is proposed using the 0.5 µm E/D-mode PHEMT process. The active balun has an amplitude imbalance of within 0.15 dB, an phase imbalance of within 1 degree, and a small signal gain of higher than 5 dB. Furthermore, the active balun is adopted to design a DC-to-12 GHz active quasi-circulator with a Darlington amplifier. The active quasi-circulator demonstrates a small signal gain of better than 5 dB, and an isolation of higher than 18 dB.Based on the proposed topology in Chapter 3, a 4.4-to-42 GHz active quasi-circulator is presented using 0.18 µm CMOS process to extend the operation frequency in Chapter 4. The isolation is higher than 22 dB and the small signal gain is better than -1 dB. In Chapter 5, a millimeter-wave (MMW) active quasi circulator in 90 nm CMOS process are designed using two pairs of matrix distributed amplifiers and three broadside couplers. Between 40 and 83 GHz, the MMW quasi circulator has an average isolation of higher than 12 dB and a small signal gain of better than 0 dB.
显示于类别:	[電機工程研究所] 博碩士論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	697	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....