English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 80990/80990 (100%)
造訪人次 : 42683844      線上人數 : 1544
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧:
  • 您可在西文檢索詞彙前後加上"雙引號",以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋,建議至進階搜尋限定作者欄位,可獲得較完整資料
  • 進階搜尋


    請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/88453


    題名: 商用 V2O5-WO3/TiO2觸媒對六氯苯破壞之研究;Destruction of Hexachlorobenzene over Commercial V2O5-WO3/TiO2 Catalyst
    作者: 范青竹;Pham, Thanh-Truc
    貢獻者: 環境工程研究所
    關鍵詞: V2O5-WO3/TiO2;氧化;六氯苯;CBz 同系物;V2O5-WO3/TiO2;destruction;hexachlorobenzene;CBz congeners
    日期: 2022-01-25
    上傳時間: 2022-07-14 01:25:55 (UTC+8)
    出版者: 國立中央大學
    摘要: 六氯苯(HeCB)是持久性有機污染物(POPs)之一,儘管全球在幾十年前已限制HeCB的產生,其仍存留於環境中,然而現今關於去除HeCB的研究很少。為了分析過程中產生的中間產物,改進分析氯苯同系物的方法,目前已成功分析氯苯同系物(三氯至六氯)。本研究中探討商業用觸媒 V2O5-WO3/TiO2 對六氯苯的去除效率,當反應溫度為160oC~200oC時,乾燥條件下200℃時HeCB去除效率可達99%,在此溫度範圍內,存在水蒸氣 (20%) 時,200oC 下最高去除效率達 94%,因此高溫可以提高觸媒活性,在較高溫度,乾燥條件及濕潤條件下去除效率從 160oC 的 8% 下降到 200oC 的 5%,代表可以克服蒸氣含量對觸媒的不利影響。但水蒸氣仍被認為是抑制 V2O5-WO3/TiO2 觸媒性能的因素。根據初步結果,1,2,4-TriCB 是在觸媒破壞過程中產生的主要含氯化合物,幾乎可全部被吸附在觸媒上,在乾燥條件及濕潤條件下,氣流和觸媒中1,2,4-TriCB 的最高總質量分別為 0.7 µg 和 0.8 µg。透過計算氯質量平衡,發現在沒有水蒸氣的情況下有35% 的氯原子不存在於含氯化合物中,若通入氣流含有水蒸氣則該值為 20%。因此,蒸氣會影響觸媒將含氯化合物破壞為 Cl2 的能力。對於HeCB而言,溫度與觸媒吸附能力呈正相關。目前該領域的研究文獻並不多,需進行更多的實驗數據來證實。;Hexachlorobenzene (HeCB) is one of the notorious persistent organic pollutants (POPs). Even though its production was restricted worldwide decades ago, HeCB still remains in the environment. However, there is a scarcity of studies conducted on HeCB removal. To assist in analyzing intermediates produced in the destruction process, a method of analyzing chlorobenzene congeners has been improved. Up to now, the procedure has been successful in the analysis of chlorobenzene congeners (from tri- to hexa-). In this research, the catalytic performance of commercial V2O5-WO3/TiO2 in HeCB destruction has been studied. When the reactor temperature ranges from 160oC to 200oC, the peak of HeCB removal efficiency could be up to 99% at 200oC in the dry condition. With water vapor (20%) and in this temperature range, the highest removal efficiency was 94% at 200oC. Therefore, high temperatures can enhance catalytic activity. At higher temperatures, the gap between removal efficiencies in dry and wet conditions declines from 8% at 160oC to 5% at 200oC, which means the adverse effect of steam content on the catalyst can also be overcome. However, water vapor is still considered the factor that inhibits the catalytic performance of V2O5-WO3/TiO2. Based on the preliminary results. 1,2,4-TriCB predominates in the chlorinated by-products during catalytic destruction, and it could be almost adsorbed on the catalyst. The highest total mass of 1,2,4-TriCB in the effluent and on the catalyst was 0.7 µg and 0.8 µg in dry and wet conditions, respectively. By calculating chorine mass balance, 35% of chlorine atoms do not present in the chlorinated compounds in the absence of water vapor. In comparsison, that value was 20% if the inlet gas stream contained water vapor. Therefore, steam can also impact the ability of the catalyst to destroy chlorinated compounds to Cl2. In terms of HeCB, there was a positive correlation between temperature and the catalytic adsorption capacity. There are currently not many scientific publications in this field, and more experiments are needed.
    顯示於類別:[環境工程研究所 ] 博碩士論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    index.html0KbHTML53檢視/開啟


    在NCUIR中所有的資料項目都受到原著作權保護.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 隱私權政策聲明