連續柴氏長晶過程中三坩堝熱傳與質傳的數值模擬;Numerical simulation of heat and mass transfer during continuous CZ crystal growth with triple crucible

NCU Institutional Repository > 工學院 > 機械工程研究所 > 博碩士論文 > Item 987654321/90145

請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/90145

題名:	連續柴氏長晶過程中三坩堝熱傳與質傳的數值模擬;Numerical simulation of heat and mass transfer during continuous CZ crystal growth with triple crucible
作者:	黎俊賢;Li, Chun-Hsien
貢獻者:	機械工程學系
關鍵詞:	連續柴氏長晶法;三坩堝;數值模擬;CCZ;Triple crucible;Numerical simulation
日期:	2022-07-27
上傳時間:	2022-10-04 12:12:18 (UTC+8)
出版者:	國立中央大學
摘要:	連續柴氏長晶法(Continuous Czochralski crystal growth, CCZ)不同於傳統柴氏長晶法(Czochralski crystal growth, CZ)在外坩堝內部設置多個隔板的設計，使得在連續進料(多晶矽顆粒)時，能夠維持熔湯的高度，使矽顆粒在融化過程能夠均勻受熱，在沿晶體⁄熔湯固液界面處不會出現未融化之矽顆粒，以至於影響所生長單晶矽晶棒之良率，但是因為多了隔板的設置，導致氧濃度上升且熔湯內的流動較不穩定，而長晶過程中的熱傳、質傳也會受到隔板的影響，於是本研究將利用數值模擬，探討外坩堝內設置兩個隔板對熔湯的流動造成的影響，以及不同隔板深度、晶體轉速、坩堝轉速，分析三坩堝的設置對長晶條件之影響。本研究比較隔板不同分區、深度，得到結果為靠近長晶區之隔板L1長和遠離長晶區之隔板L2短的設計，能阻擋氧氣與熱量傳入長晶區以減少固液界面之氧濃度，而本研究最後比較了單坩堝、雙坩堝、三坩堝之硼摻雜效果，而結果表明使用三坩堝進行硼摻雜，雖然氧濃度相比單坩堝、雙坩堝是會高出許多，但是熔湯內部之硼摻雜濃度分佈均勻且摻雜濃度較其他兩者高。 ;The continuous Czochralski crystal growth (CCZ) method is different from the traditional Czochralski crystal growth (CZ) method in which multiple partitions are set inside the outer crucible, so that when the continuous feeding (polysilicon particles) is used to maintain the height of the melt, so that the silicon particles can be heated evenly during the melting process, and there will be decreases the unmelted silicon particles in the solid-liquid interface of the crystal/melt, so as to affect the yield of the single crystal silicon ingots grown. However, due to the addition of partitions, the oxygen concentration increases and the flow in the melt is unstable, and the heat transfer and mass transfer during the crystal growth process will also be affected by the partitions. Therefore, this study will use numerical values simulation is carried out to discuss the influence of two partitions in the outer crucible on the melt flow, and the depth of the partitions, the crystal rotation rate and the crucible rotation rate. This study compares the different partitions and depths of partitions. The results obtained are that the partition L1 near the crystal growth zone is long and the partition L2 far away from the crystal growth zone is short. The design can block the introduction of oxygen and heat into the crystal growth zone to reduce the oxygen concentration along the crystal/melt interface. And this study finally compared the boron doping effect of single crucible, double crucible, and triple crucible, and the result was that three crucibles were used for boron doping, although the oxygen concentration was much higher than that of single crucible and double crucible, but the boron doping concentration distribution inside the melt is uniform and the doping concentration is higher than the other two.
顯示於類別:	[機械工程研究所] 博碩士論文

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
index.html		0Kb	HTML	28	檢視/開啟

在NCUIR中所有的資料項目都受到原著作權保護.

社群 sharing

資料載入中.....